Working Principle Of Punching And Die Cutting Machine

1 Working principle

Punching and Die Cutting Machine working principle is the use of die-cutting knives, knives, metal molds, steel wire (or steel plate carved into the template), Punching 

and Die Cutting Machine through the pressure plates to exert a certain pressure, printing or cardboard rolled into a certain shape. If the entire printing press cut into a 

single graphic product called die-cutting, if the use of steel wire on the printed product or leave a bend of the groove mark is called indentation; by heating the mold to

 a certain temperature, printing on the surface of the printed product has a stereo effect of the pattern or font called bronzing; if a substrate is reused on another substr

ate, it is referred to as a fitting;

2 Field of work
Punching and Die Cutting Machine applications:

1), Adhesive Products: A variety of electronics: Electrical Special Rubber pads, silicone stickers, magic stickers, conductive adhesive, strong double-sided Adhesive,

 backlight screen, such as electronic industry, IT industry membrane switch, automotive industry used adhesive products.

2), dustproof material: cosmetic cotton, camera cotton, high-density sponge, filter cotton, dust-proof net, Non-woven fabric.
3), Shockproof Products: Back to force rubber pads, rubber, Punching and Die Cutting Machine transparent mats, Poron pads, 3M, flame retardant Eva, high foaming.
4), insulating materials I: Fire fast bar paper, aluminum foil, copper foil, PVC, PET, Kraft, sponge sheath, pearl sheath.
5), EMI Shielding Materials: Copper foil, aluminum foil, conductive cloth, absorbent material.
6), Heat insulation: Silicon film, transparent mica, fiber cloth, insulation cotton (cloth).
7), paper packaging materials: corrugated, wrapping and cardboard.
3 Work procedures
Punching and Die Cutting Machine stamping products Note:

1), before the use or interval of a working period of time, Punching and Die Cutting Machine the machine operating parts of lubricating oil (please add $number special 

butter);

2), the use of the process do not use the hand or other parts of the body into the die-cutting area, please use infrared protection device;
3). Please install and debug the mould in the case of power cut-off;

4), machine stamping products maximum stamping load does not allow more than the nominal pressure of the machine, long-term load work, reduce machine life, 

Punching and Die Cutting Machine damage to the fuselage;

5), work or debugging should follow the gradual, do not card board, such as card board, please immediately stop, troubleshooting after use.